DIY Accessory Holder

So if you’re anything like me since you have gone natural you started buying a whole bunch of hair accessories & earrings. But then after you start accumulating all of this stuff…where to put it right ?? Well I went to a Natural Hair Expo not to long ago & I bought an earring holder

cute right πŸ™‚

I was thinking about ordering another one of these but bigger. The thing is I paid $20 for the size I have so imagine how much the bigger ones are… a lot !! Anyway I recently bought some frames on the clearance rack planning to put some pics in them & then bing the light bulb went off (or did it come on ?? lol) The earring holder I have is only held together by a wire mesh & glue. How hard could it be to recreate this ?!? Not hard at all πŸ™‚ All you need is your creativity & a few items and off you go.

Here’s what you need…

I paid $8.99 for the wire mesh at A.C. Moore. I used about three & 1/2 glue sticks

The wire mesh I used was 16×20 and the frame was 14×18
So let’s begin…

lift the place holders then…

remove the backing & glass out of the frame
Β The place holdings need to be pushed up & bent over the frame

Unfold the wire mesh & use your thumb to smooth out the creases (as best as you can)

while you’re smoothing out the wire let your glue gun heat up (or you can use any type of craft glue you choose)


Once the glue gun is heated apply glue to the center of each side of the frame & press the wire mess over the glue

press the wire mesh over the edge of each end of the frame so as to even it out

Glue the frame on each corner & push the wire mesh over it then glue over the mesh to ensure that it stays on

Then allow to dry

After drying cut off the excess wire hanging over the edges with extra sharp scissors

Next step is to apply the hooks. I’m using paper clips πŸ™‚ but you can use what you want

Hold the back of the mesh while you apply the paper clips (stick in the hole 1st then turn upside down

unbend the paper clip before putting on the holder (easy as 1, 2, 3)

Apply a larger paper clip to hang the holder & secure with glue

Allow to dry. As I was saying at the beginning of this post, I have accumulated a lot of hair accessories (a recent haul/raid of my $ store below =)

I love these bows because you have 3 options on how you can wear them & yes they were $1 each !! I’m going to use the clip on the back of the bow to attach to…yes you guessed it the paper clip πŸ™‚


You can use your holder for whatever you like (mix & match hair accessories with earrings, etc) You can also display your holder wherever you want. I put mine on a corner wall in my bedroom : ) Happy DIYing !!